Recently, readers asked about storing and packing models. I split my models into those of equal span and configuration. I cut slots in the sides of a cardboard box to receive the wings. The slots should be snug and deep enough to keep the spinner off the box bottom. The model fits so pitot tube, antennas, ordnance, and other items are in the clear.

I have been able to fit five 1/32 scale models nose down so landing gear and flaps and canopies do not collide. This mode allows clearance between tail sections also. The models ride well with no padding on the wing leading edges, no scratching, no hangar-rash problems. A rear seat in a most cars will hold three of these boxes with little problem, and this takes less than an hour per box to construct! I cut hand holds in either end of the box for ease of transfer.

Tip submitted by:
Capt. Alan Edwards
Olga, Wash.